2.4g Sub-G Dual Band Wireless RF Module SoC 433mhz 868mhz 915mhz Transceiver Module CC1352 CC1352p
[IC]：CC1352P
[Frequency]：431~500MHz
[Power]：20dBm/4.5dBm
[Distance]：1.5km/0.12km
[Size]：32*20mm
[Weight]：2.8±0.1g
[Introduction]：Based on TI CC1352P chip, E79-400DM2005S is a dual-band ARM-based RF SoC Module designed by Ebyte, with max transmitting power of 20dBm at SUB-1GHz and 5dBm at 2.4GHz. The module integrates a high-performance wireless transceiver and a low temperature drift.
| No. | Name | Direction | Function |
|---|---|---|---|
| 1 | GND | - | Ground wire, connected to the power reference ground |
| 2 | VCC | - | Power supply, range 2.5-3.7v (external ceramic filtercapacitor is recommended) |
| 3 | SETB | Input/output | Ground wire, connected to the power reference ground |
| 4 | DIO1 | Input/output | Multipurpose digital IO cannot be used as external GPIO |
| 5 | BUSY | Input/output | SPI busy indicator that cannot be used as an externalGPIO |
| 6 | I2C_SDA | Input/output | I2C SCL pins |
| 7 | I2C_SCL | Input/output | I2C SDApin |
| 8 | UART_CTS | Input/output | UART CTS pin |
| 9 | UART_RTS | Input/output | UART RTS pin |
| 10 | GND | - | Ground wire, connected to the power reference ground |
| 11 | ANT | - | Antenna interface, stamp hole (50 ohm characteristicimpedance) |
| 12 | GND | - | Ground wire, connected to the power reference ground |
| 13 | GND | - | Ground wire, connected to the power reference ground |
| 14 | GND | - | Ground wire, connected to the power reference ground |
| 15 | GND | - | Ground wire, connected to the power reference ground |
| 16 | XRES | Input | External reset pins |
| 17 | ADC_IN | Input | ADC input pin |
| 18 | AUX | Input/output | MCU GPIO |
| 19 | SETA | Input/output | MCU GPIO |
| 20 | UART_RX | Input/output | UART RX pin |
| 21 | UART_TX | Input/output | UART TX pin |
| 22 | SWD_DATA | Input/output | SWD Data pins |
| 23 | SWD_CLK | Input/output | SWD Clock pin |
| 24 | GND | - | Ground wire, connected to the power reference ground |
| 25 | SPI_MISO | Input/output | SPI MISO test point, internally connected, cannot be used as external SPI |
| 26 | SPI_NSS | Input/output | SPI NSS test point, internally connected,cannot be used as an external SPI |
| 27 | SPI_MOSI | Input/output | SPI MOSI test point, internally connected,cannot be used as an external SPI |
| 28 | SPI_SCK | Input/output | SPI SCK test point, internally connected,cannot be used as external SPI |